Tot Chilly Bank- Case of 6

Description

29855 Tot Chilly Bank- in Ceramic Cone 04 Bisque By Duncan

All of our bisque is fired to a cone 04 and is ready to paint.

Case of 6

4 x 4 x 5.86

This item is unpainted.

You are purchasing an unfinished, Ready to Paint, Piece of Ceramic Pottery

Chilly Change Collector

Start a spending freeze and save your coins in the Duncan® Oh Four® Tiny Tot Chilly Bank. Concepts® Underglazes and Duncan® Fired Snow gives this adorable arctic animal a look that’s a twist on the traditional tuxedo.

Instructions:

  1. Wipe ware with damp sponge to remove bisque dust.

  2. Paint three coats Bright Nautical to penguin’s head, fins and back. Refer to photo. Let dry after each coat.

  3. Paint three coats Bright Butternut to beak and feet. Let dry after each coat.

  4. Using Liner brush, paint eyes and toenails with two good coats Black. Let dry after each coat.

  5. Dip pencil eraser into the Bright Nautical and gently stamp one dot onto center of penguin’s tummy. Next, dip pencil eraser into the Neon Red and make dots around the Bright Nautical dot.

  6. Use the back end of paintbrush handle to make a small dot of Bright Butternut on each side of penguin’s cheeks. Make Neon Red dots around Bright Butternut dots. Let dry.

  7.  Use Liner brush loaded with Apple Green and brush leaves on flippers and leaves on penguin’s back.

  8. Make more pencil dots to create Neon Red flower with Bright Butternut center on back of penguin just above the tail. Add Apple Green leaves on each side below flower. Let dry.

  9. Scratch in stem between leaves on flippers and back. Make to scratch deep enough to ensure the white bisque shows through.

  10. Carefully sponge on Pure Brilliance to white areas of penguin being careful not to smudge colors into the light areas. Let dry. Add a second sponging to entire penguin. Let dry.

  11. Use Palette Knife to stir Fired Snow. Use palette knife to apply the snow to top of penguin’s head leaving coin slot open. Add a little snow to penguin’s beak, flippers and toes. Let dry.

  12. Stilt and fire to witness cone 06.

NOTE:  If desired, fire penguin without the Pure Brilliance at witness cone 06. Once the colors have set, brush one coat of Pure Brilliance to face and stomach (white) areas. Let dry. Apply a second, more diluted Pure Brilliance coat to entire penguin. Firing twice may prevent any smearing of colors when brushing on Pure Brilliance.

What you need:

Tot Chilly Bank (29855)

Tools

TL 420 Palette Knife

TL 411 Stylus

Specialty Products

 SY 546 Duncan® Fired Snow

Signature Brushes

SB 807 No. 6 Fan Glaze 

 SB 806 No. 6 Round

 SB 802 No. 1 Liner 

Clear Glazes

Duncan® Pure Brilliance® Clear Glaze

Duncan® Concepts® Underglazes for Bisque

CN 032 Bright Butternut

CN 122 Bright Nautical

CN 253 Black

CN 507 Neon Red

CN 512 Green Apple

Miscellaneous:

Pencil (new) with eraser on end

Container for water

Potter’s sponge

Foil or foam plate for palette